![]() ![]() ![]() There are seven different timing ranges from which to choose. In Repeat Cycle mode, the check input allows the timer to be used like a binary flip-flop or alternating relay. When check input is used in ONdelay mode, the elapse time measurement of the set time is not performed - especially useful where ON-delay override is desired. When the gate opens, timing resumes at the point of interruption. When the gate input is closed, timing is temporarily stopped. Simply connecting them to the common terminal (Pin 3 or 15) via a switch, relay contact, open collector sensor, and etc., is all that is required to activate each input. The inputs (Start, Reset, Gate, and Check) on this timer are considered a no voltage or dry contact thus requires no external voltage source to activate. Any application of this timer should be designed to prevent bodily injury, or property damage, in the event of product failure or normal wearout of this product. ![]() Do not install in damp or moist locations.ĥ. Protect the coil and load circuits with properly rated fuses.Ĥ. Do not connect input or contact terminals to voltages higher than those indicated on timer.ģ. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |